Hayes Waterslide Decal Paper A4 (8.3”x11.7”) For LASER Printers


For LASER Printers

Personalize unique designs onto ceramics, glass, jade, metal and plastic materials.


Product Details

For LASER Printers

Application Instructions:

  1. Print your design onto Hayes Paper Co.® – Water-slide Decal paper, using a laser printer.
  2. Use scissors to cut out your design. Do NOT cut right to the edge of your design, leave 2-3mm of spacing.
  3. Fill your bowl with room temperature water. Submerge you pre-cut decal for 30-60 seconds or until the middle of the decal can easily be slid around. Remove from water.
  4. Quickly apply it to your clean decal surface. Position decal, backing side down and gently slide backing off. Keep the backing flush with your project as you gently pull it out from behind the decal.  Press firmly, use your fingers, a damp cloth/ paper towel or a mini squeegee to remove air bubbles. Gently pad off any excess water.
  5. Let the decal set and dry for at least 3 hours. Don’t expose to direct sunlight during this time.

Ceramics can be baked in an oven at 230 degrees Fahrenheit for 10-15 minutes. Ceramics are NOT dishwasher safe and should be cleaned by a gentle hand wash.

Epoxy can be applied over the entire project to give a final glass like finish. Epoxied projects are NOT dishwasher safe and should be cleaned by a gentle hand wash.

Product may come rolled if also ordered with vinyl and may need to be flattened under something like a book before putting into printer.

Additional information

Number of Sheets

1 Sheet, 10 Sheets, 25 Sheets, 50 Sheets


Clear (Transparent), White


There are no reviews yet.

Be the first to review “Hayes Waterslide Decal Paper A4 (8.3”x11.7”) For LASER Printers”

Your email address will not be published.

Go to Top